FSB Overclocking Results

Front Side Bus Overclocking Testbed
Processor: Pentium 4 Smithfield LGA 775
840EE Dual Core 3.2GHz
CPU Voltage: 1.5500V-1.6000V (1.4000V default)
Memory Settings: 3-2-2-8 at 667MHz
Memory Voltage: 2.2V
NorthBridge Voltage: 1.50V
SouthBridge Voltage: 1.05V
Cooling: Thermaltake Big Typhoon
Power Supply: OCZ Power Stream 520
Maximum CPU OverClock: 270fsb x 16 (4327MHz) +35%
Maximum FSB OverClock: 305fsb x 14 (4274MHz) +52%

This board is an excellent overclocker considering the CPU utilized. At this overclock setting, the system was able to complete all of our benchmark test suites three consecutive times and run Prime95 and SuperPI without issue. We were able to overclock the FSB to 315 at the 14x multiplier, which resulted in CPU operation of 4410MHz, but could not complete our test suite.


Memory Stress Testing

Memory stress tests look at the ability of the Asus P5WD2-Eto operate at the officially supported memory frequencies of 667MHz DDR2, at the best performing memory timings that the Corsair CM2X512A-5400UL revision 1.3 will support.

Asus P5WD2-E
Stable DDR667 Timings - 2 DIMMs
(2/4 slots populated - 1 Dual-Channel Bank)
Clock Speed: 200MHz (800FSB)
Timing Mode: 667MHz - Default
CAS Latency: 3
RAS to CAS Delay: 2
RAS Precharge: 2
RAS Cycle Time: 8
Voltage: 2.1V

The Asus P5WD2-E was completely stable with 2 DDR2 modules in Dual-Channel at the settings of 3-2-2-8 at 2.1V.

We will now install all four available memory slots that are usually more strenuous on the memory subsystem than testing 2 DDR2 modules on a motherboard.

Asus P5WD2-E
Stable DDR667 Timings - 4 DIMMs
(4/4 slots populated - 2 Dual-Channel Banks
Clock Speed: 200MHz (800FSB)
Timing Mode: 667MHz - Default
CAS Latency: 3
RAS to CAS Delay: 2
RAS Precharge: 3
RAS Cycle Time: 8
Voltage: 2.15V

The Asus P5WD2-E was completely stable with 4 DDR2 modules in Dual-Channel at the settings of 3-2-3-8 and only needed the voltage increased to 2.15V.

ASUS P5WD2-E: Features Asus P5WD2-E: 955EE Overclocking
Comments Locked

20 Comments

View All Comments

  • kilkennycat - Monday, January 16, 2006 - link

    If the board is not 100% compatible, both physically and electrically with the upcoming Conroe family of processors, I suggest that everybody take a pass. It would be just another case of Intel screwing us again with fast-track (deliberately-?)planned obsolescence ---- just as they did on the LGA775 family when the earlier boards and chipsets were (er...) "found" not to be compatible with their dual-core offerings ---which of course nicely inflates demand for Intel chipsets. And again where Yonah has exactly the same pin-count as the Pentium-M, but deliberately physically incompatible such that even the latest Pentium-M motherboards will not work with Yonah. After all, Intel needs to recoup its recent $350million investment in expanding its chip-set fabrication capability and as fast as possible. Would not like to disappoint the stockholders.

    Also a corollary question --- is the 975X chip-set itself fully compatible with Conroe, or is it going to have a short and unhappy life like the 915/925 chipset ??

    Gotta really admire Intel in the past couple of years. While their processor engineering lost its way, their marketing gurus have become geniuses at finding all sorts of neat ways of lubricating the screw and keeping the cash rolling in.
  • danidentity - Monday, January 16, 2006 - link

    Besides price, what is the advantage of this board over the P5WDG2-WS? Is the P5WD2-E a better overclocker than the P5WDG2-WS? Would you recommend the P5WD2-E over the P5WDG2-WS, price aside?
  • Gary Key - Monday, January 16, 2006 - link

    quote:

    Besides price, what is the advantage of this board over the P5WDG2-WS? Is the P5WD2-E a better overclocker than the P5WDG2-WS? Would you recommend the P5WD2-E over the P5WDG2-WS, price aside?


    The P5WD2-E is targeted towards the overclocking market and for mainstream use as it should come to market about $35~$50 less than the P5WDG2-WS. The other advantage it holds is the additional PCI-E slots and one additional PCI slot if you need them, otherwise the PCI-X slots on the G2-WS will certainly hold an advantage for the workstation crowd.

    I personally think the G2-WS is a better board at this point in the release cycle mainly due to a more mature bios and the 8-phase power solution. However, we have several more 975X boards to review and will hold final judgement until that testing is completed.
  • mostlyprudent - Monday, January 16, 2006 - link

    In the initial 955EE review, there was a claim that the high heat levels might be related to the Intel supplied motherboard. Was there any difference with this ASUS board?
  • Gary Key - Monday, January 16, 2006 - link

    quote:

    In the initial 955EE review, there was a claim that the high heat levels might be related to the Intel supplied motherboard. Was there any difference with this ASUS board?


    We did not notice the same thermal issues the first set of the Intel D975XBX boards had with the 955EE. In fact, our replacement D975XBX solved the initial thermal issues we noticed. However, the 955EE still runs very warm, we noticed 49c at idle and up to 68c under load on the Asus board with either the Gigabyte G-Power or Thermaltake Big Typhoon coolers. The provided Intel heatsink (840EE) ran at 55c idle and up to 73c under load but we understand this might not be the heatsink shipped in the retail kit. We are trying to procure one at this time to test it.
  • Marlin1975 - Monday, January 16, 2006 - link

    You say there is a problem with the 882 chips? Can you run the same test on boards that used the same south bridge with a Cmedia sound chip. I know a lot of boards used the c-media at first and am whondering if this is maybe a south bridge problem or just another sign of the low quality items/drivers that realtek seems to make.

    Never been a realtek fan. Weather it be their low quality sound chips or their drivers.
  • Gary Key - Monday, January 16, 2006 - link

    The 882 family of codecs is very good for an on-board solution. I believe there is still a lot of work to be done in the drivers. However, the improvements made between the R1.20 release up to the R1.29 release have been significant. We actually could watch our BF2 benchmark come to a stop during the aircraft flyovers up until the R1.27 release. There is still some stuttering and frame rates drop into the teens but overall the CPU hit rate is around 9% compared to a 67% CPU hit in drivers up to R1.26. The overall sound quality has improved in games like Serious Sam II and F.E.A.R. also. We have not tested a 975X board with the CMedia solution but have just finished testing one with the Sigmatel solution (next article).
  • ProviaFan - Monday, January 16, 2006 - link

    The review states that with two ATI cards inserted, the other PCI-E slots are not usable. Is this due to a real hardware limitation, or is it only because the ATI cards' coolers are too big? An example of a usage scenario that prompted this question: could I put a graphics card in one 16x slot running at 8x, an 8x PCI-E SCSI adapter in the other physical 16x slot, and then perhaps a 1x card in one of the remaining slots?
  • Gary Key - Monday, January 16, 2006 - link

    quote:

    The review states that with two ATI cards inserted, the other PCI-E slots are not usable. Is this due to a real hardware limitation, or is it only because the ATI cards' coolers are too big?


    The slots are physically not available due to the two slot cooling solutions used on the cards. This would hold true for the 6800 Ultra or 7800GTX 512mb edition cards.

    Your scenario about the slot assignments would work.
  • coldpower27 - Monday, January 16, 2006 - link

    Interesting on the voltage for the CPU though having only 1.200V as the bottom limit seems a little bit limiting from my persepctive, good gaming performance though as it typically runs only 2nd to the Intel Nforce 4 SLI.

    I also agree that 8 Phase Power would be nice, maybe in a future revision that is made to support Intel's NGMA processors.

Log in

Don't have an account? Sign up now