Music on the Rockus 3D

Music playback testing was done much more comprehensively than I had previously; I tried just about everything. The first issue I took with the Rockus 3D, but one that became progressively more minor as I became accustomed to the character of the sound the system produced, was that the high end feels a bit tinny. Double-blind with the Bose, the Rockus generally sounded better and produced clearer, more dynamic sound that was in many cases far less muddy. The problem is that some of that muddiness did mask compression and artifacting in some of the songs; you can't really fault the speakers for doing what they're told, but the highs can be so thin that it can get to the point of making some of the artifacts physically painful to listen to.

The sound also isn't quite as rich and full as one would hope. It certainly has worlds more depth than you'll get from a hundred dollar speaker set, but the highs and mids nonetheless can feel a bit thin and sometimes don't feel like they're separating quite as well as they could. You'll pick up nuances and details in the music better than you might with cheaper speakers; I just wish the sound had more body in those regions. When you get to the lows, the subwoofer does a solid if unexceptional job of picking up the rear. Not having a more fine-grained control over the subwoofer's power beyond the three presets hurts, but even the highest preset can feel a little weak.

Across different types of music, I found that industrial and electronic music could actually feel the thinnest in the highs and mids, but softer more instrumental fare works far, far better. If "Spitfire" by The Prodigy produces a good if not outstanding listening experience, something more downtempo like Red Hot Chili Peppers' "Otherside" can sound quite lovely.

Trying to buff up those thin highs and mids through the equalizer is an exercise in futility, though, and this is one of the Rockus 3D's biggest perks and worst flaws: the speaker system is calibrated to sound as good as it possibly can from the factory, a point the Antec rep was keen on mentioning and something that I can confirm in practice. The Rockus 3D is never going to sound better than it does shipped from the factory, and tweaking the equalizer in either analog or digital connection modes only seemed to make it worse.

That said, across the board the Rockus 3D sounded better than the Bose Companion II's attached to the Xonar DX.

While playing music, however, just go ahead and keep your finger off the 3D mode. It allows the speakers to suddenly produce a tremendous amount of body, but it more or less massacres the arrangement of the instruments in whatever you happen to be listening to. On a couple of songs I felt like the listening experience was slightly improved by 3D mode, but in almost everything else the distortion completely ruined them. Listening to music in 3D mode on the Rockus is akin to watching a standard-aspect movie stretched across an HDTV.

Testing the Rockus 3D Movies and Games on the Rockus 3D
Comments Locked

67 Comments

View All Comments

  • DanD85 - Thursday, November 18, 2010 - link

    I'm not sure if Antec sound better than Edifier. I know it's quite unfamiliar brand name around here but I've heard it and it really really good. The price is quite reasonable too.
    http://www.edifier.ca/english/speakers/s330d/s330d...
  • warisz00r - Thursday, November 18, 2010 - link

    As an owner of the S330D I can definitely vouch this poster's opinion. The Edifier compares pretty well with the Klipsch Promedia 2.1 and is also way better than any similarly priced 2.1 systems from Logitech and AL.
  • Patrese - Thursday, November 18, 2010 - link

    Agreed as well. I have a set of Edifier E3100 for 5 years now and they're easily the best sounding 2.1 computer sets I've ever heard.
  • The0ne - Monday, November 29, 2010 - link

    I have two sets of Klipsch Promedia 2.1 and don't have any complaints. They're un-used mostly now because of my Z5500s but they are still very good when I do use the other PCs. I have another comparable 2.1 but can't remember the brand name, urgh. It also has very good sound qualities and still going strong.
  • dramaqueen - Wednesday, July 8, 2015 - link

    Edifiers are decent but what about the Harman Kardon SoundSticks?
    http://www.pricenfees.com/best-2-1-speakers.html
    Can't really compete when it comes to overall sound quality IMO.
  • wtfbbqlol - Thursday, November 18, 2010 - link

    Things like:

    - Frequency response
    - THD+N
    - Speaker sensitivity

    Unfortunately to make all these things happen, and have them be valid, you'll have to go all out and have an anechoic chamber with proper measurement equipment (measurement mics, and hardware testers like some Audio Precision stuff) for your measurements. If you don't have an anechoic chamber, use maximum-length sequence type measurements to circumvent room reflections.

    Anyway, my point is, if you can't at least provide some valid baseline measurements a purely subjective review is more or less useless. Better spend Anandtech time on other more useful stuff.
  • ninjaquick - Thursday, November 18, 2010 - link

    S/N, FR are almost always marketing gimmicks. While it is true that many high quality speakers advertise these values, their relevance is questionable at best.

    Ultimately it is the subjective hearing tests that matter most. The shape of the enclosure, the aspiration of the drivers/woofers., the material of the cones and even the wires used inside the system + the amplification/DACs all affect how the system will sound past the S|N/FR statements. What I am getting at is until you hear how it sounds you will never know how it sounds. I could, right now, grab top shelf drivers and wires, get it to be 15hz-25khz / 112 dB S/N but they would sound awful. Hell, even with null THD they would sound bad.

    I don't even care anymore to get to where I was going.
  • wtfbbqlol - Thursday, November 18, 2010 - link

    Without some form of valid lab measurements you have no reference to judge the audio performance. The measurements aren't an absolute metric of what sounds good or bad, but its value is in showing whether the product has any gross deviations/defects in its audio performance. For example, if I see weird 10dB peaks or dips over a wide band in the frequency response, I am almost certainly sure that the audio product is not worth my time at all.

    What the reviewer thinks "sounds good" to him/her may not be good for you. His/her ears are not yours. Meanwhile, measurements which are done properly, even if they don't give the full picture, allows you some way to gauge the audio performance and compare one like product to another.

    Also, notice I suggested that Anandtech perform their own lab measurements, and not use the advertised "specs" of these products. It's a huge undertaking, make no mistake about it, and one I think Anandtech is currently ill-equipped to deal with currently and is of questionable value even if they do. It's going to take a lot of money, time, and effort just to improve one small portion of their output. Either do it right, or don't.

    I'm going to be blunt; this kind of review doesn't belong on Anandtech. I expect rich analysis like some of the better hardware articles here (SSD, motherboard reviews etc).
  • wtfbbqlol - Thursday, November 18, 2010 - link

    For example, here is a page from a speaker review of another site with reasonable effort put into some of the measurements.

    http://www.audioholics.com/reviews/speakers/booksh...
  • anactoraaron - Thursday, November 18, 2010 - link

    I would agree with this. I am only going to compare and refer anyone reading this post to Anand's SSD trilogy. The depth of how nand works wasn't necessary nor was the controller's inpact on performance and why, but it is that depth that makes Anandtech.com what it is. This article just doesn't match up with the SSD articles. I know this is more of an issue of "the manufacturer sent us this to review it and this is the only way we are able to do so as of now" but maybe this should be filed under the News section and brief specs listed there, rather than doing this and calling this a full fledged review.

    my 2c

Log in

Don't have an account? Sign up now